manual typo + configuration problem

[Minetti]

On bottom of page 22 of the manual, examples of configuration files, it says "Select the one you need (such as printer_output)". I guess it should be output_printer.
Speaking of this, I have first tried to change config files and could not do it. With Bitvise, from within root/config/, when I type "nano output_printer" I get the message "Error writing lock file ./.output_printer.swp: no space left on device"
The content of the file is shown, and it was the default value "Yes". When I change it to "Raw" and save the file, it says "save the buffer content" I say yes, and it exits. Opening again "output_printer" shows an empty file with a message "Error reading lock file ./.output_printer.swp: Not enough data read".
As a newbie in this filed, I may be missing something really obvious, but I'm stuck. Any help wuld be greately appreciated.
Thanks

[RWAP]

Thanks for the feedback on the manual - I have corrected this typo for the next version of the manual.

Not being able to edit the config files is puzzling indeed - we are talking via email to get to the bottom of this, as it sounds as though the SD card is corrupt?

[RWAP]

We have found the problem that can cause the device to fill.

It is to do with the hplip printer drivers.
You MUST run the command

Code: Select all

snap remove hplip-printer-app
logrotate -f /etc/logrotate.d/rsyslog
logrotate -f /etc/logrotate.d/cups-daemon

We will uload a new v3.15 shortly