Okay thanks HNY BTW , any idea of scale to try for printer_delay config?
e.g. Is it a case of changing from 5-6? or 5-10? or 5-100?
Okay thanks HNY BTW , any idea of scale to try for printer_delay config?
Actually the Beeb and Electron exhibit exactly the same behaviour. This is the main reason I switched over to the Electron from the Beeb when starting testing.
I suspect this is closer to the issue, as I do vaguely remember having to set the LF DIP switch in my Epson FX80 BITD when I owned my first Beeb.
We should be able to implement this, I will check...holding printer interface PIN 14 LOW will also replicate this AUTO_LF behaviour
Extending the auto_linefeed sounds very logical, as this is then providing the same functionality as the EPSON hardware
Code: Select all
CR+BUFF
Hi Rich,RWAP wrote: ↑Wed Jan 13, 2021 7:47 pm OK I seem to have figured out what the Electron is expecting the printer to do.
Try: https://www.dropbox.com/s/m1kggyq7ywvr9 ... C.img?dl=0
I have set the auto_linefeed tobut you may need to set the Epson_pins to 9Code: Select all
CR+BUFF