RetroPrinter Support

We received the initial batch of Retro-Printer modules last week and have shipped quite a few around the globe already.

No feedback has been received yet - but hopefully the buyers will join this forum and share their experiences so that we can improve the software as required.

To purchase:

• Retro-Printer Module itself - https://www.sellmyretro.com/offer/detai ... a%29-32773

• Case for the Retro-Printer Module + Raspberry Pi - https://www.sellmyretro.com/offer/detai ... dule-32774

• and the optional 16GB SanDisk micro-SD card with adaptor, pre-programmed with the software image - https://www.sellmyretro.com/offer/detai ... d%29-32775

We would just like to thank our customers for their support following the withdrawal of the original v3 Retro-Printer modules from sale earlier this year.

We will however, soon be offering the v3 modules for sale at a reduced price for development / test purposes, along with a cable adaptor to correct the manufacturing fault on the centronics connector. This will not address the problem on the Raspberry Pi 3 Model B+

The v4 Retro-Printer module will be released in the near future - see our other discussions on this.

Existing v3 users (pre April 2019) will be offered a free v4 Module as a replacement.

There is a limited number of v3 Modules now listed on sellmyretro - https://www.sellmyretro.com/offer/detai ... odel-37159

This does not work with the Raspberry Pi 3 B+ and so is being sold at a reduced price.

The v4 module is currently being tested!