RetroPrinter Support

Posted: **Sat Sep 16, 2017 2:50 pm**

On both the RPi 2+ and RPi3 the standout holes don't seem to line up. Do we have different dimensions for RPi in the USA or do we just need to adjust the PCB size to match?

You can see the center line of the standout offset to the PCB hole.

Posted: **Sat Sep 16, 2017 3:37 pm**

This is something we are aware of - although I managed to screw my unit together without any issue

Posted: **Mon Apr 16, 2018 10:48 am**

This has been resolved in the v3 PCB

RetroPrinter Support

PCB doesn't line up with RPi

PCB doesn't line up with RPi

Re: PCB doesn't line up with RPi

Re: PCB doesn't line up with RPi